Board logo

标题: 请问有懂飞机制造里复合材料(CFK)加工技术的同学嘛? [打印本页]

作者: 海平线    时间: 2009-5-22 15:04     标题: 请问有懂飞机制造里复合材料(CFK)加工技术的同学嘛?

想请教一下纤维铺放技术和树脂渗透
作者: 辣椒炒肉    时间: 2009-5-22 18:53

fibres are deposited with thin films by physical vapour deposition and hot pressed at high temperature.
作者: 海平线    时间: 2009-5-22 23:07

请问有德语的资料的链接吗?
作者: rwthaachener    时间: 2009-5-23 10:30

versuch mal bei http://www.ilr.rwth-aachen.de/
作者: alex365    时间: 2009-5-23 10:40

Moulding methods
In general, the reinforcing and matrix materials are combined, compacted and processed to undergo a melding event. After the melding event, the part shape is essentially set, although it can deform under certain process conditions. For a thermoset polymeric matrix material, the melding event is a curing reaction that is initiated by the application of additional heat or chemical reactivity such as an organic peroxide. For a thermoplastic polymeric matrix material, the melding event is a solidification from the melted state. For a metal matrix material such as titanium foil, the melding event is a fusing at high pressure and a temperature near the melt point.
For many molding methods, it is convenient to refer to one mold piece as a "lower" mold and another mold piece as an "upper" mold. Lower and upper refer to the different faces of the molded panel, not the mold's configuration in space. In this convention, there is always a lower mold, and sometimes an upper mold. Part construction begins by applying materials to the lower mold. Lower mold and upper mold are more generalized descriptors than more common and specific terms such as male side, female side, a-side, b-side, tool side, bowl, hat, mandrel, etc. Continuous manufacturing processes use a different nomenclature.
The molded product is often referred to as a panel. For certain geometries and material combinations, it can be referred to as a casting. For certain continuous processes, it can be referred to as a profile.




欢迎光临 人在德国 社区 (http://rs238848.rs.hosteurope.de/bbs/) Powered by Discuz! 7.2